Philips Speaker System HTS3111 User Manual

Register your product and get support at  
HTS3111  
EN User manual  
NO Brukerhåndbok  
DA Brugervejledning  
DE Benutzerhandbuch  
EL Εγχειρίδιο χρήσης  
ES Manual del usuario  
FI Käyttöopas  
PT Manual do utilizador  
SV Användarhandbok  
TR Kullanım kılavuzu  
CS Příručka pro uživatele  
HU Felhasználói kézikönyv  
PL Instrukcja obsługi  
RO Manual de utilizare  
SK Príručka užívateľa  
FR Mode d’emploi  
IT Manuale utente  
NL Gebruiksaanwijzing  
 
Contents  
1
Notice  
Compliance  
Mains fuse (UK only)  
Trademarks  
2
Important  
Safety  
Product care  
Disposal of your old product and batteries  
Contact us  
3
Your SoundBar  
Main unit  
Remote control  
4
5
Connect your SoundBar  
Connectors  
Use your SoundBar  
Before you start  
Play audio fromTV or other devices  
Adjust the volume  
Choose your sound  
Apply factory settings  
6
Wall mount your SoundBar  
7
Product specifications  
EN  
1
 
Trademarks  
1 Notice  
Compliance  
Manufactured under license under U.S. Patent  
#’s: 5,451,942; 5,956,674; 5,974,380; 5,978,762;  
6,487,535 & other U.S. and worldwide patents  
issued & pending. DTS and the Symbol are  
registered trademarks & DTS Digital Surround  
and the DTS logos are trademarks of DTS, Inc.  
Product includes software. © DTS, Inc. All Rights  
Reserved.  
This product is in compliance with the essential  
requirements and other relevant provisions of  
Directives 2006/95/EC (Low Voltage), 2004/108/  
EC (EMC).  
Mains fuse (UK only)  
This product is fitted with an approved moulded  
plug. Should it become necessary to replace the  
mains fuse, this must be replaced with a fuse of  
the same value as indicated on the plug (example  
10A).  
Dolby, Pro Logic and the double-D symbol are  
trademarks of Dolby Laboratories.  
1
2
Remove fuse cover and fuse.  
The replacement fuse must comply with BS  
1362 and have the ASTA approval mark. If  
the fuse is lost, contact your dealer in order  
to verify the correct type.  
3
Refit the fuse cover.  
Note  
To conform with the EMC directive  
(2004/108/EC), the mains plug on this product  
must not be detached from the mains cord.  
2
EN  
 
       
If the product is transported in  
2 Important  
Read and understand all instructions before you  
use your SoundBar. If damage is caused by failure  
to follow instructions, the warranty does not apply.  
temperatures below 5°C, unpack the  
product and wait until its temperature  
matches room temperature before  
connecting it to the power outlet.  
Risk of overheating!  
Never install this product in a confined  
space. Always leave a space of at least four  
inches around the product for ventilation.  
Ensure curtains or other objects never  
cover the ventilation slots on the product.  
Safety  
Risk of electric shock or fire!  
Never expose the product and accessories  
to rain or water. Never place liquid  
containers, such as vases, near the product.  
If liquids are spilt on or into the product,  
disconnect it from the power outlet  
immediately. Contact Philips Consumer  
Care to have the product checked before  
use.  
Never place the product and accessories  
near naked flames or other heat sources,  
including direct sunlight.  
Never insert objects into the ventilation  
slots or other openings on the product.  
Risk of contamination!  
Danger of explosion if battery is incorrectly  
replaced. Replace only with the same or  
equivalent type.  
Remove battery if it is exhausted or if the  
remote control is not to be used for a long  
time.  
Battery contains chemical substances, it  
should be disposed of properly.  
Risk of swallowing batteries!  
The product/remote control may contain a  
coin type battery, which can be swallowed.  
Keep the battery out of reach of children at  
all times!  
Where the mains plug or an appliance  
coupler is used as the disconnect device,  
the disconnect device shall remain readily  
operable.  
Disconnect the product from the power  
outlet before lightning storms.  
When you disconnect the power cord,  
always pull the plug, never the cable.  
Risk of short circuit or fire!  
Before you connect the product to the  
power outlet, ensure that the power  
voltage matches the value printed on the  
back or bottom of the product. Never  
connect the product to the power outlet if  
the voltage is different.  
Risk of injury or damage to the SoundBar!  
For wall-mountable products, use only the  
supplied wall mount bracket. Secure the  
wall mount to a wall that can support the  
combined weight of the product and the  
wall mount. Koninklijke Philips Electronics  
N.V. bears no responsibility for improper  
wall mounting that results in accident, injury  
or damage.  
Never place the product or any objects  
on power cords or on other electrical  
equipment.  
EN  
3
 
   
Product care  
Contact us  
Only use microfiber cloth to clean the product.  
Warning  
Risk of electric shock. Never remove the  
Disposal of your old product  
and batteries  
casing of the product.  
To keep the warranty valid, never try to repair the  
product yourself.  
If you have problems using this product, register  
welcome.  
If you contact Philips, you will be asked for the  
model and serial number of your product. The  
model number and serial number are on the  
back or bottom of your product. Write the  
numbers here:  
Your product is designed and manufactured with  
high quality materials and components, which can  
be recycled and reused.  
Model No. __________________________  
Serial No. ___________________________  
When this crossed-out wheeled bin symbol is  
attached to a product it means that the product  
is covered by the European Directive 2002/96/  
EC. Please inform yourself about the local separate  
collection system for electrical and electronic  
products.  
Please act according to your local rules and do not  
dispose of your old products with your normal  
household waste.  
Correct disposal of your old product helps to  
prevent potential negative consequences for the  
environment and human health.  
Your product contains batteries covered by the  
European Directive 2006/66/EC, which cannot be  
disposed with normal household waste.  
Please inform yourself about the local rules on  
separate collection of batteries because correct  
disposal helps to prevent negative consequences  
for the environmental and human health.  
4
EN  
 
     
Remote control  
3 Your SoundBar  
Congratulations on your purchase, and welcome  
to Philips!To fully benefit from the support that  
Philips offers, register your SoundBar at  
1
2
Main unit  
1
2
3
4
7
6
3
4
a
(Standby-On)  
Switch the SoundBar on.  
When the SoundBar is on standby, the  
standby indicator is red.  
5
b SOURCE  
Select an audio source.  
c
+/- (Volume)  
Increase or decrease volume.  
d LED indicator  
Blink when a remote control button is  
pressed.  
a
(Standby-On)  
Switch the SoundBar on.  
When the SoundBar is on standby, the  
standby indicator is red.  
5
6
b Source buttons  
AUX: Switch your audio source to the  
AUX connection.  
OPTICAL: Switch your audio source  
to the optical connection.  
COAXIAL: Switch your audio source  
to the coaxial connection.  
e Source indicators  
Light up when the source is selected.  
MP3 LINK: Switch your audio source  
to the MP3 link connection.  
f Sound mode indicators  
DTS: Light up when you play a source  
with DTS.  
DOLBY D: Light up when you play a  
source with Dolby Digital.  
DVS: Light up when you select DVS  
mode.  
EN  
5
 
     
c SURROUND  
Switch to DVS mode or stereo mode.  
Press and hold to set night mode.  
1
d TREBLE +/-  
Increase or decrease treble.  
e VOL +/-  
Increase or decrease volume.  
f BASS +/-  
Increase or decrease bass.  
g MUTE  
Mute or restore volume.  
2
3
Replace battery  
Warning  
The product/remote control may contain a  
coin type battery, which can be swallowed.  
Keep the battery out of reach of children at  
all times!  
Caution  
The battery contains perchlorate material,  
handle it with care. For information see www.  
dtsc.ca.gov/hazardouswaste/perchlorate.  
1
2
Open the battery compartment.  
Insert one CR2025 battery, with the  
polarity (+/-) as indicated.  
3
Close the battery compartment.  
6
EN  
 
Bottom connectors  
4 Connect your  
SoundBar  
1
2
This section helps you connect your SoundBar to  
aTV and other devices. For information about the  
basic connections of the SoundBar and accessories,  
see the Quick start guide.  
3
Note  
Refer to the type plate at the back or bottom  
of the product for identification and supply  
ratings.  
Before you make or change any connections,  
ensure that all devices are disconnected from  
the power outlet.  
a DIGITAL IN-OPTICAL  
Connect to the optical audio output on a  
TV or digital device.  
b DIGITAL IN-COAXIAL  
Connect to the coaxial audio output on a  
TV or digital device.  
Connectors  
c AUDIO IN-AUX L/R  
Side connector  
Connect to the analog audio output on a  
TV or analog device.  
Back connector  
M
P
K
3
L
I
N
MP3 LINK  
Audio input from an MP3 player.  
SUBWOOFER  
Connect to the subwoofer.  
EN  
7
 
   
Choose your sound  
5 Use your SoundBar  
This section helps you use the SoundBar to play  
audio from connected devices.  
This section helps you choose the ideal sound for  
your video or music.  
Change treble or bass  
Before you start  
Change the high frequency (treble) or low  
frequency (bass) settings of the SoundBar to suit  
your video or music.  
Check that you make the necessary connections.  
Play audio fromTV or other  
devices  
Press TREBLE +/- or BASS +/- to increase or  
decrease treble or bass.  
The LED indicator on the front panel lights  
up for five seconds when the treble or bass  
is set to maximum.  
Press the Source buttons to select the audio  
output of the connected device.  
Change virtual surround mode  
Adjust the volume  
DVS (Dolby Virtual Speaker) technology  
creates a highly compelling 5.1-channel listening  
experience from as few as two speakers.  
To increase or decrease volume, press VOL +/-.  
Press SURROUND to switch DVS mode or  
stereo mode.  
The LED indicator on the front panel lights  
up for five seconds when the volume is set  
to maximum.  
» In DVS mode, the DVS indicator lights  
up on the top panel.  
To mute sound, press MUTE.  
» The LED indicator on the front panel  
blink continuously.  
Change night mode  
To restore the sound, press MUTE again or  
press VOL +/-.  
For quiet listening, decrease the volume of loud  
sounds when you play discs. Night mode is only  
available for Dolby encoded DVD and Blu-ray  
discs.  
Press and hold SURROUND to switch night  
mode on or off.  
» When the night mode is on, the  
indicators dim.  
8
EN  
 
         
Apply factory settings  
6 Wall mount your  
SoundBar  
For detailed steps about how to wall mount your  
SoundBar, refer to Quick start guide.  
You can reset your SoundBar to the default  
settings programmed at the factory.  
In AUX mode, press TREBLE+, VOL-, and BASS+  
within three seconds.  
» When the restore factory settings  
process is complete, the standby  
indicator blinks five times.Your SoundBar  
automatically switches off and back on  
again.  
Note  
You can remove the three rubber feet at the  
bottom of the SoundBar before wall mount.  
If the rubber feet are removed, you cannot  
place them back again at the bottom of the  
SoundBar.  
EN  
9
 
   
7 Product  
specifications  
Note  
Specification and design are subject to change  
without notice.  
Amplifier  
Total output power: 100W RMS (30%  
THD)/ 75W RMS (10% THD)  
Frequency response: 20 Hz-20 kHz / ±3dB  
Signal-to-noise ratio: > 65 dB (CCIR) /  
(A-weighted)  
Input sensitivity:  
AUX: 1.0 V  
MP3 LINK: 0.5 V  
Audio  
S/PDIF Digital audio input:  
Coaxial: IEC 60958-3  
Optical: TOSLINK  
Main Unit  
Power supply: 110-240 V~; 50-60 Hz  
Power consumption: 20 W  
Standby power consumption: ≤ 1 W  
Impedance: 4 ohm woofer, 4 ohm tweeter  
Speaker drivers: 65 mm (2.5”) woofer, 38  
mm (1.5”) tweeter  
Frequency response: 150 Hz ~ 20 kHz  
Dimensions (WxHxD): 945 x 93 x 58 mm  
Weight: 1.7 kg  
Subwoofer  
Impedance: 3 ohm  
Speaker drivers: 165 mm (6.5”) woofer  
Frequency response: 20 Hz-150 Hz  
Dimensions (WxHxD): 123 x 309 x 369  
mm  
Weight: 3.81 kg  
Cable length: 4 m  
Wall Mount  
Dimensions (WxHxD): 260 x 40 x 15 mm  
Weight: 0.16 kg  
10 EN  
 
 
© 2010 Koninklijke Philips Electronics N.V.  
All rights reserved.  
sgptt_1049/12_v2  
 

Pelco Video Game Keyboard C581M B User Manual
Philips Digital Camera LTC0600 User Manual
Philips DVD Recorder DVDR3355 User Manual
Philips Handheld TV MPR975A101 User Manual
Pioneer CD Player DEH P3150 B User Manual
Planet Technology Switch WGD 800 User Manual
Poulan Snow Blower PR624ES User Manual
Procom Network Router EVS200 User Manual
ProSpot Fitness Treadmill AT110 User Manual
PYLE Audio Car Amplifier PLCD88USMP User Manual